qwed
All guides

Connecting your KMBox, MakCU, Ferrum or Arduino

4 min read, updated

ESP and radar work without a mouse device. Aimbot, triggerbot and recoil control move your mouse through one, so it has to be connected first. Everything is on the Devices page of the menu.

Wiring

  • Your mouse plugs into the device. The device plugs into the gaming PC like a mouse.
  • The device's control cable goes to the second PC (USB). A KMBox Net is reached over the network instead.

MakCU, Medius, Ferrum and other KM boxes

QOWED finds them by itself: first a MakCU by name, then the port that worked last time, then it asks every USB serial port and takes the one that answers. Medius firmware is recognised automatically.

  1. Devices page, MakCU / Medius card. It shows Connected once found.
  2. Not found? Press Scan ports, or pick the port yourself under Pick the port yourself and press Use. Windows' Device Manager, Ports (COM and LPT), shows which COM port your box is on.
  3. Press Test move: your mouse should nudge to the right. Test click sends one left click.

KMBox B+ / USB

  1. Devices page, KMBox card: Plugged in over USB, press Reconnect.
  2. Press Test move.

KMBox Net

  1. Devices page, KMBox Net card: enter the Address, Port and identifier. All three are printed on the device or shown on its screen.
  2. Press Connect, then Test move.

Arduino

An Arduino only moves the mouse; your buttons stay on your own mouse.

  1. Devices page, Arduino card: pick the Port, then the speed and firmware your board runs (SunOne or KMBox commands).
  2. Press Connect, then Test move.

Test move works, but the aim does nothing

  • Aimbot page: is it on, and is a Key set under Activation? Hold mode only aims while you hold that key.
  • Hold your aim key, then press Copy on the Devices page, Support card, and paste it into your ticket. It shows whether the key press reached QOWED.